Main Features Of New Energy Vehicles
Mar 10, 2025
Leave a message
Hybrid vehicles
Hybrid vehicles have three layout types: series, parallel and hybrid.1. Series means that the engine drives the generator to generate electricity, and its electricity is directly transmitted to the motor through the motor controller, and the motor generates electromagnetic torque to drive the car.
1. Performance characteristics are:
(1) The working state of the engine is not affected by the driving conditions of the car, and it always runs stably in its optimal working area. Therefore, the engine has good economy and low emission indicators.
(2) Since there is a battery to "peak" the driving power, the engine power only needs to meet the power required for the stable operation of the car at a certain speed, so a smaller engine can be selected
(3) There is no mechanical connection between the engine and the drive axle, so there is no requirement for the engine speed, and the engine selection range is large, such as a high-efficiency prime mover such as a high-speed gas turbine.
(4) There is no mechanical connection between the engine and the motor, and the structural layout of the whole vehicle has a large degree of freedom
(5) The output of the engine needs to be fully converted into electrical energy and then converted into mechanical energy to drive the car, which requires a generator and motor with sufficient power.
(6) To achieve a good balance between the output power of the generator and to avoid overcharging or overdischarging of the battery, a larger battery capacity is required.
(7) The generator converts mechanical energy into electrical energy, the motor converts electrical energy into mechanical energy, and the charging and discharging of the battery all result in energy losses. Therefore, the energy utilization rate of the engine output is relatively low.
2. The parallel type refers to the engine being connected to the drive axle through a mechanical transmission device, and the motor being connected to the drive axle through a power compound device. The car can be driven by the engine and the motor together or separately. Its performance characteristics are as follows:
(1) The engine directly drives the car through a mechanical transmission mechanism, and there is no organic-electrical energy conversion loss. Therefore, the utilization rate of the engine output energy is relatively high. When the driving conditions of the car make the engine run within its optimal operating range, the fuel economy of the parallel HEV is higher than that of the series type.
(2) With the motor performing the "peak shaving" function, the engine power can also be appropriately reduced.
(3) When the motor is only used as an auxiliary drive system, the power can be relatively small.
(4) If equipped with a generator, the power of the generator can also be relatively small. (5) Since there is a generator to supplement the power, a relatively small battery capacity can meet the use requirements.
(6) Since the engine operating conditions of the parallel drive system are affected by the driving conditions of the vehicle, when the driving conditions of the vehicle change more and more, the engine will operate more often under its unfavorable conditions. Therefore, the engine's pollution discharge is higher than that of the series drive system.
(7) Due to the direct mechanical connection between the engine and the drive axle, a speed change device is required to adapt to the changes in the vehicle's driving conditions. In addition, the parallel drive of the engine and the electric motor also requires a power compound device. Therefore, the transmission mechanism of the parallel drive system is more complicated.
3. The hybrid drive system is a combination of the series and parallel types, which means that part of the power generated by the engine is transmitted to the drive axle through mechanical transmission, and the other part drives the generator to generate electricity. The structural form and control method of the hybrid drive system give full play to the advantages of series and parallel types, enabling more optimized matching of components such as the engine, generator, and motor, thereby structurally ensuring that the system works in the optimal state under more complex working conditions, making it easier to achieve emission and fuel consumption control targets.

